Before performing machine tool maintenance or cleaning, the upper mold should be aligned with the lower mold and then put down and shut down until the work is completed. If startup or other operations are required, the mode should be selected in manual and ensure safety. The maintenance content of CNC bending machine is as follows:
1. Hydraulic oil circuit
a. Check the oil level of the fuel tank every week. If the hydraulic system is repaired, it should also be checked. If the oil level is lower than the oil window, hydraulic oil should be added;
b. The oil of a new CNC bending machine should be changed after 2,000 hours of operation. The oil should be changed after every 4,000 to 6,000 hours of operation. The oil tank should be cleaned every time the oil is changed:
c. The system oil temperature should be between 35°C and 60°C, and shall not exceed 70°C. If it is too high, it will cause deterioration and damage of the oil quality and accessories.
2. Filter
a., Every time you change the oil, the filter should be replaced or cleaned thoroughly:
b. If the bending machine tool has relevant alarms or other filter abnormalities such as unclean oil quality, it should be replaced.
c. The air filter on the fuel tank should be inspected and cleaned every 3 months and preferably replaced every year.
3. Hydraulic components
a. Clean hydraulic components (substrate, valves, motors, pumps, oil pipes, etc.) every month to prevent dirt from entering the system and do not use cleaning agents;
b. After using the new bending machine for one month, check whether there are any deformations at the odd bends in each oil pipe. If there are any abnormalities, they should be replaced. After two months of use, the connections of all accessories should be tightened. The system should be shut down when doing this work. The pressure-free hydraulic folding machine includes a bracket, a workbench and a clamping plate. The workbench is placed on the bracket. The workbench is composed of a base and a pressure plate. The base is connected to the clamping plate through a hinge. The base is composed of a seat shell, a coil and a cover plate. , the coil is placed in the depression of the seat shell, and the top of the depression is covered with a cover plate.
When in use, the coil is energized by the wire, and after the current is energized, the pressure plate is induced to clamp the thin plate between the pressure plate and the base. Due to the use of electromagnetic force clamping, the pressing plate can be made into a variety of workpiece requirements, and workpieces with side walls can be processed.
If you have any questions or confusion about the care and maintenance of MACRO CNC bending machines, you can please contact us at any time, we will help you to resolve your doubts at any time.
Post time: Nov-04-2024